#349 - EN-2 ELECTRONIC SPEED CONTROL WITH REVERSE
For use with motors down to 21 turn
EN-2 Micro ESC with Reverse. As standard in the Micro RS4.
- Input Voltage: 7.2V-8.4V(NiMH)
- Output: Rating: 35A, Peak: 60A
- Out max power :25A/7.2V (Max 180W)
- Size: 23x29x18.8mm
- Weight: 19.5g
- BEC: 5V/1A
- P.W.M: 1KHz
- Motor limit :380 brushed motor [≤7.2V (6cells)]
Please note: This ESC does not have LiPo Low Voltage Cut-Off Protection, therefore it is not suitable to be used with LiPo Battery Packs.
NOTE: NOT WATERPROOF! Before driving in wet conditions, make sure that all electronics fitted to the vehicle are safe to use (marked as water-resistant or waterproof), or that they are fully enclosed and protected from water and moisture (such as in a sealed receiver/battery case). Fans mounted on speed controllers are not water resistant - we recommend to disconnect the fan from the ESC before driving in wet conditions and allow it to dry fully before reconnecting the fan power. Lubricate exposed metal drivetrain parts such as bearings, outdrives and diff shafts before driving in wet conditions. Motors are not intended for submerged use and may be damaged if used when under water. After driving in wet conditions, make sure to rinse off dirt and any corrosive liquids like saltwater with plain water and re-lubricate metal drivetrain parts.
Download PDF instructions for #349 (0.8 MB)