Racer Gallery

main page | week 1 | week 2 | week 3 | week 4

Peter DeFeo

My name is Peter DeFeo. This is my RS4 3 RTR Evo. Hop-Ups include, HPI Lamborghini Murcielago Body 200mm, HPI High Performance Air filter, Dubro Fuel Filter, Ofna Fail Safe, HPI Racer Fuel Tank.

 

Jose

My name is Jose, I live in Bogotá/Colombia Here is my latest touring body... It is a Toyota Supra....

 

Jared Larson

I submitted my Rush stadium truck back in August '03 and at the end of the description I said "Up next is a Savage SS kit" Well here she is....

Savage SS kit
-SH .25 Pro engine run on Byrons 25%
-HPI Ribbed Tuned Pipe (stock)
-GPM sliding clutch w/ Alum. shoes
-Twisted Toys custom TVPs, designed my me: 1” ext., 7075 T6 3mm aluminum
-Twisted Toys engine plate
-RC Alloys custom center dogbones
-HPI HD wheel dogbones (stock)
-GPM Alumium diff housings
-Envy Kevlar dual disk brakes
-Hot Bodies steel brake hex/hub
-HPI adjustable upper arms (stock)
-WFC Yellow Rally springs
-Lunsford titanium turnbuckles
-Maximizer 5-Hole black bead locks
-Motor Saver air filter
-MGT fuel tank
-Dubro fuel filter
-HPI Reverse
-6V 1100mah hump pack
-OFNA micro failsafe
-XTM X-175 MG steering servo
-Hitec 525 BBS throttle/brake servo
-Airtronics 94102 reverse servo
-Aluminum servo horns
-Hex screws from boltdepot.com
-Trinity Pro antenna tube

All topped off with a Jeep Wrangler Rubicon body.
Pactra Paint: Outlaw Black, Bright Yellow, backed in White Covercoat.

Mods
-Driveline dust boot mod
-OFNA linkage mod
-OFNA MP servo saver mod
-Diff Mod w/ 100K oil front/rear
-Tie-rod washer mod

My Custom Stuff
-Battery Relocation Mod
-Failsafe Window
-Steel Roll Bar out of 3/16” flat bar
-Diamond Plate center skid plate attached w/ alum. engine plate braces
-Relocation of receiver on/off switch w/ switch cover
-MGT Fuel tank guard
-Front/Rear skid plate braces swapped out with alum. engine plate braces
   

 

Betino Mortensen

Hello

I would like to have my car in your gallery and here is the spec. about my car:
As shown on the pictures this car is a Nitro rs4 RTR3 evo with a 200mm HPI Nissan 350Z body. I used a airbrush and used these colours: Chamelon: Orange, purple, teal and Fasblack. The window trim is painted black.
I´m using blue Hotworks 26mm wheels.
main page | week 1 | week 2 | week 3 | week 4

Think you can do better? See our R/C Photography Tips and send us your pictures!

Racer's Gallery index