Assembly Instructions - Page 18, Step 26
To the Main Assembly Instructions Page
This is where we get to the wheels and tires!
Step 26
Use a hobby knife to peel off the thin foam strips from one of the two small sheets of foam. The foam pads are pre-cut, and one sheet of foam will be applied to two wheels.
The part numbers listed in the instruction manual are the specific part numbers for the foam sheets; one foam sheet is packaged with each pair of extra tires. Although the part numbers are different, the foam sheets are the same and can be interchanged.
On the front (narrow) wheels, apply the foam strips against the inside the wheel lip, as shown below.
For the rear (wide) wheels, center the foam strips in the center of the reinforcing ribs.
The foam strips should be evenly mounted around the wheel.
