Assembly Instructions - Page 13, Step 15
To the Main Assembly Instructions Page
Now we build the front universal dogbones.
Step 15
Using your hobby knife, cut away the parts required for Step 15: parts 4 and 7 from the #73404 tree and part 11 from the #73403 tree (pictured below).
Trim the flashing from the dogbone with the knife.
Using needle nose pliers, install the metal pins in both dogbones.
Make sure the pins stick out equally on both sides of the dogbones.
Use the L-wrench to hold the universal ball joint and slide the dogbone over one of the pins on the ball joint.
Then, snap the opposite side of the dogbone over the pin on the opposite side of the ball joint. Repeat for the other dogbone.
Snap the axles onto the universal ball joints to complete the assembly of the universal dogbones..
