Show Discontinued Kits

#102784 - SERVO HPI SF-10 (4.5kg-cm 6.0V)

Raccord servo standard/Futaba J

Arrêté, replacement part: #104105

Standard Parts

Beef up the steering of your buggy or truck with the powerful HPI SF-10 servo! With a speed of 0.18 seconds to move 60 degrees and a monster 4.5kg of power per centimeter (at 6 volts, the standard power from a 5-cell receiver battery), you get strong steering at low or high speeds if using the SF-10 as a steering servo, or extremely strong brakes if using it as a throttle/brake servo.

The SF-10 uses a standard Futaba 'J' connector so it's a simple matter to connect it to any RC receiver, so it will work in any RC car or truck. It features a 25-tooth spline and standard screw hole spacing so it's easy to connect to your car. 

NOTE: NOT WATERPROOF! Before driving in wet conditions, make sure that all electronics fitted to the vehicle are safe to use (marked as water-resistant or waterproof), or that they are fully enclosed and protected from water and moisture (such as in a sealed receiver/battery case). Fans mounted on speed controllers are not water resistant - we recommend to disconnect the fan from the ESC before driving in wet conditions and allow it to dry fully before reconnecting the fan power. Lubricate exposed metal drivetrain parts such as bearings, outdrives and diff shafts before driving in wet conditions. Motors are not intended for submerged use and may be damaged if used when under water. After driving in wet conditions, make sure to rinse off dirt and any corrosive liquids like saltwater with plain water and re-lubricate metal drivetrain parts. 

Download PDF instructions for #102784 (0.2 MB)

Select your region:

Select your language:

Obtenir plus de HPI! Se connecter à MYhpi maintenant!

Please select your region and language settings